Back Zip Heeled Ankle Boots

The satin finish on this faux leather has a low, even sheen rather than a hard shine, and it follows the close cut of the shaft so the boot reads as one clean line from the square toe up to the top edge. The zip sits at the back, which keeps both sides and the vamp completely plain, and it runs low enough for the foot to pass through without forcing. The block heel is set squarely under the heel of the foot at a moderate lift, and the slim rubber sole keeps the profile trim while still giving a bit of hold on smooth flooring.

Key details

• Satin finish upper: faux leather with a soft low sheen instead of a hard gloss.
• Close cut shaft: follows the ankle closely, with no gaping at the back of the leg.
• Back zip fastening: keeps the vamp and both sides of the boot free of hardware.
• Squared toe: a flat front edge with the corners softened off.
• Covered block heel: wrapped in the same faux leather and set square beneath the foot.

Specifications

• Upper: Satin finish faux leather
• Lining and insole: Textile lining with a padded textile insole
• Sole: Slim rubber sole
• Heel height: around 6 cm
• Toe shape: Square toe
• Fastening: Back zip
• Weight: around 680 g per pair
• Care: Wipe with a soft damp cloth and store away from direct sunlight

Size guide

Measure your foot from heel to the tip of the longest toe and choose the closest size. If you are between two sizes, we recommend the larger one.